Replica Watches Tourbillon Adjustment

In order for replica watches tourbillon to work properly, it is very important to adjust the tourbillon. The tourbillon is an important movement mechanism in the watch. It can offset the influence of gravity on the movement of the watch and improve the accuracy and stability of the watch.

Here are the steps to adjust your tourbillon:

1. Remove the back cover of the watch

Remove the back cover of the watch to expose the internal structure of the watch. Under the dust cover, you can see the position of the tourbillon. The tourbillon is usually located on the top layer of the movement and is covered by a metal cover.

2. Remove the tourbillon cover

Use a tourbillon-sized screwdriver to remove the tourbillon cover, using caution to avoid damage to the movement. Once the cover is removed, the tourbillon and tourbillon axis can be seen. There are two screws on the shaft. By adjusting these screws, the speed of the tourbillon can be adjusted.

3. Rotating tourbillon screw

Use a screwdriver to carefully turn the screw on the tourbillon and adjust the position of the tourbillon axis to change the speed of the tourbillon. It is recommended to gradually adjust in small increments until the desired speed is achieved.

4. Measurement speed

After adjusting the tourbillon, you need to measure the adjusted speed. Measurement methods include using a meter or manual timing. If the speed is normal, put the tourbillon cover and back cover back into place and seal the watch.

Any watch adjustment operation needs to be handled with caution. The adjustment of the tourbillon requires experienced technicians. If you are not skilled, it is recommended to leave it to a professional watch repairman. With proper maintenance and repair, your watch can have a longer service life while maintaining accurate time.